The engine is heavily modded. It has a set of Wiseco higher compression pistons from a group buy set up by David a few years ago. He had them Swain coated for me at the same time. The rods are Scat h-beams wwith ARP 2000 cap screws. Total Seal gapless rings, a custom cam David had made up for me. The intake has been welded in and modified. Heads and mains are studded with a 94 windage tray added. High volume oil pump and Morana double roller along with the torrington thrust spacer I just purchased from David. Heads are ported with Manley severe duty 7mm valves, beryllium alloy seats and bronze guides, Comp springs with Manley ICD titanium retainers and locks. Flow numbers were 250/196. I modified the pedestals to use a Crane 351C guide plate conversion kit to reduce movement of the 1.8 aluminum roller rockers. Pushrods are Comp heavy wall.
I purchased a brand new MPX from Charles with the new abraded rotors. I also bought the larger 95mm tb but he never got the larger prototype inlet back to copy so I ended up modifying the regular MPX inlet myself. The inlet elbow has also been enlarged in the necked down area. I have a 4 inch cold air tube, 95mm C&L MAF and 80lb Motron injectors. Everything will be controled by a Moates quarterhorse and a custom tune David wrote for it.
The headers are Kook's midlength going into a Flowmaster Force II system. My brother and I spent a couple of days tweaking a Magnum Powers intercooler setup so that an all aluminum 4 core Mustang rad could fit. Originally he made some alluminum brackets so that we could use the factory fan but it was way too thick with the waterpump pulley hitting the housing. I picked up a Maradyne Mach 1 and we made new brackets for it. Even though it was 2 inches thinner, it still came close. We machined a 1/2" aluminum spacer to suck the motor into the housing and it looks good now.
The transmission is a 4R70W from a 2001 Mustang and has a B& M deep pan. It will be controlled with Bauman stand alone shift controller and their custom harness. I had a Mark 8 aluminum driveshaft shortened to account for the longer transmission and I have a Cobra aluminum pumpkin with 3.55's, an Auburn posi and Control Freak thicker cover.
I will update the progress as things are installed. I have to figure out why all my photos were rotated 90 degrees too. Lol.