1990 sc problems

Pullomikko90

Registered User
Hello from Finland i bought 1990 sc project,
It have harmonic balancer broken and bolt is in camshaft.

I dont know why its not start on, i bought new coil pack, new spark plugs+wires. Always i start cylinder fill with fuel. It have spark but not so good spark, is it crank sensor bad or DIS module?
 
Check these threads:
http://www.sccoa.com/forums/showthr...sition-Sensor&highlight=cranks+sensor+bracket

http://www.sccoa.com/articles/crankshaftsensor.php - but I think the small bolts are 5.5mm?

Short version is discussed here: http://www.sccoa.com/forums/showthr...sensor!!&highlight=how+to+change+crank+sensor

An alternative is to remove the bracket that holds the cranksensor from the engine, and then work on them both outside of the car. Photos in this thread:
http://www.sccoa.com/forums/showthread.php?73797-Crank-censor&highlight=cranks+sensor+bracket

The bracket with sensor is shown here too: https://www.supercoupeperformance.com/crank-sensor-and-bracket-for-the-89-93-38l-sc-engine-634
 
Last edited:
Okay its hard to find crankshaft sensor in Finland,
Were i can find that for cheap do you have any crankshaft sensor an additional? If i dont find crankshaft sensor for cheap i have to sell that sc in parts...
 
Okay its hard to find crankshaft sensor in Finland

It is hard to find a crankshaft sensor anywhere. They are no longer available new. I sold two used ones in the last few months and do not know where more are at this time.

You may have to be patient.
 
Back
Top