ok, got my O2 sensors replaced. Seemed to fix the idle for the most part. It was still idling just a little rough. I know that I need new mounts, but they are not totally gone yet. When the engine is in gear, and you rev it, there is still less than an inch of movement by the engine. I'm guessing that I have more though. Wile driving home from putting on the new O2 sensors, the CE light came on. This is a first. Driving about 30mph and about 1300 RPM and the CE light came on. usually at that rpm, even in 'P' the engine will idle nice and smooth. I'm guessing it is not the mounts in this case. No other lights came on i.e. upshift arrow, check sensor, etc.) Could it be the cam sensor, or TPS or IAC? I'm going to try to get the codes pulled this afternoon, but until then, and even after, what should I be looking for. Engine mounts are planned for March or April time frame. I need it to run until then...