Car won't start. OPINION???

I had the broken balancer, broken bolt, etc, which I fixed with BHJ balancer, ASP underdrive pulleys, mustang bolt and washer. I did not replace the crank position sensor. Car ran fine. I just replaced the supercharger pulley with a ESM 5% pulley, and car ran great...... until it stalled, and was very difficult to restart. I got the car home, and it will not start. Last nite I checked codes with my "paper clip" scan tool (after I cleared the computer...MISTAKE). The scan revealed on the check engine light:
*..*....*..*..........*..........*..*.....*..*
(*= flash, .= pause)
Looks to me like code 11 (system pass) .
My shift light stays on when cranking (sign of bad crank sensor?). With my "scan tool" connected, there is no shift light.
Does this indicate a bad crank sensor?

90 SC 5 spd

Ya, usually it does mean that if car won't start at all. You can see if it is just out of alignment. Maybe it has to much of a gap and a simple adjustment will fix it.