wtb...SOMETHING!

[scxr7]

I've got a hole burning in my pocket and I'm not sure what to buy. I'm looking for bolt-on stuff. I've got 60lb injectors, mpx, plenty of overdrive, good-enough exhaust, and a fmic.

I'm thinking that for bolt on stuff, maybe I should get an 85mm throttle body, since superchargers need as little restriction as possible on the intake side.

also maybe a camshaft or some stiffer valve springs. I'd like to run a cam in my car, but Its hard to find a set of valve springs. I remember a while back dave got a set of stock replacement springs that could go up to .570 lift but those are discontinued due to cost.

other than those two things, I'm thinking maybe a set of wider rear rims, like 15x8". My stock 15x6.5" rims wont get traction at all.

this is a 1/4 mile car only, so I'm not really interested in suspension junk for now. I'm not sure what to do about the IRS for drag racing. Maybe junk it for a SRA I'm not sure yet.

But like I said, I'm interested in performance stuff. since my transmission has been at the tranny shop for 2 months now getting built up to be bullet proof, I have nothing to do.

[kamakazie_1]

Ah.. send check, I'll spend it for you!!

RJ

[SC1day]

If your looking for a cam, I have a new comp cam stage 2 for $250.

SPECS:
RPM Operating Range: 1500-6000 RPM
Duration: Advertised Intake 265, Advertised Exhaust 281.
@ .050" Intake 210, @ .050" Exhaust 226
Valve Lift: Intake .500, Exhaust .500
Lobe Separation Angle: 114

http://supercoupeperformance.com/par...spx?partId=468

Originally Posted by kamakazie_1

Ah.. send check, I'll spend it for you!!

RJ

[scxr7]

Can I use stock springs and retainers for this cam?? what about pushrods and rockers. Do I need longer pushrods or different rockers? If I can just plug and play, I'll buy it.

[BECERRASC]

that you can have for the change....
but no returns....

[fturner]

Do you have a chip and a tune etc setup for the car?

Fraser

[scxr7]

yep I have a diablo chip. I might take you up on the ex-girlfriend tho lol.

Also, I'm looking for good used pistons and rods from a s/c motor. I blew my THIRD motor today...I gotta buy another motor..so maybe I'll be in the market for a new/used motor!!! if anyone has one, let me know

[scxr7]

bump! I'm in the mood to spend!

I'm still waiting on a response from sc1day

[TinManSC92]

don't take the ex. the cars are by far cheaper.