6
Reaction score
4

Latest activity Postings About

    • 6
      64th-35th replied to the thread No Start.
      Had to take some time off on this , I did check footwells , thanks . will be diving back in soon..
    • 6
      64th-35th replied to the thread No Start.
      Am I correct in assuming that because the brake lights work that the brake switch is working for the neutral safety switch also ?
    • 6
      64th-35th replied to the thread No Start.
      Wire from firewall bulkhead to solenoid is good . It had a dealer installed anti theft system when new , after about 5 years it started...
    • 6
      64th-35th replied to the thread No Start.
      I have power to ignition switch , power to the start wire leaving ignition switch , tracing wire back to solenoid ..
    • 6
      64th-35th replied to the thread No Start.
      All seat connections are good , there is an extra female plug /pin connector that looks like its never been used. Both dash grounds are...
    • 6
      64th-35th replied to the thread No Start.
      While doing the dash , both seats came out along with the carpet for shampooing . so today I'm pulling drivers seat cause there's about...
    • 6
      64th-35th replied to the thread No Start.
      Bulkhead pins had grease on the tips, cleaned , reassembled along with every connection under dash , no change , no start . Is there...
    • 6
      64th-35th replied to the thread No Start.
      Are the main electrical bulkhead connector pins suppose to have dielectric grease on them ?
    • 6
      64th-35th replied to the thread No Start.
      Total agreement , thanks for your support
    • 6
      64th-35th replied to the thread No Start.
      No back up lights , 4 ways and turn signals work on the outside but not on the dash , going to disconnect and inspect and reconnect...
    • 6
      64th-35th replied to the thread No Start.
      Could the fuel safety switch in the trunk be the problem and how do you reset it ?
    • 6
      64th-35th replied to the thread No Start.
      Installed new Ignition switch , no change . Installed new solenoid , no change , but does spin the motor over when jumped at solenoid ...
    • 6
      64th-35th replied to the thread No Start.
      Getting new ignition switch , checking brake connections ,thanks
  • Loading…
  • Loading…
Top