American50

Hello, for my '95 SC with the OEM camshaft, do you know where I can find the valve timing events, ie, intake valve opens at ? degrees...

Hello, I did see his comment, but it doesn't answer my question. I need to find the valve timing events, ie, degrees before/after...

Hello, for my '95 SC with the OEM camshaft, do you know where I can find the valve timing events, ie, intake valve opens at ? degrees...

Hello, Does KOER stand for "key on engine running ? Thank-you.

Here are 2 pictures of stalk showing correct orientation and vane in middle of notch. Fuel pressure stays at 40psi while idling. #1...

Thank-you for the photos and the explanation. After rebuilding my '94 SC engine, I'm having problems getting it started. It looks like...

The tools used by Ford can be purchased online here: http://www.thetoolwarehouse.net/shop/OTC-6467.html But an easier way to line it up...

I knew I had this sitting around somewhere.... FIND Top Dead Center #1 Start by knowing you have your engine on top dead center number...

It says not to use RTV. The supercharger top and the inlet plenum must also be resealed properly when they are separated from the...

Will this help you? https://www.supercoupeperformance.com/intercooler-resealing-tape-gasket-eliminator-712

answer : I think I found my answer, from another sccoa post from a few years back.:: "Those O-rings are not for sealing the tubes to...

Those gaskets work wonders if you have stock or double IC and stock pipes. Mine always leaked until I put the gaskets on. I didn't...

Those are my gaskets on Ebay. They are not factory, but rather a re-useable gasket that requires no cleaning during re-installation...

Hello, Thank-you for your message. It looks like that is what I need. I did use Loctite 518 flange sealant at the two plenums. Could I...

OK, thank-you for this information. In fact, I did use Loctite 518 flange sealant at the plenums. Could I use the same product at the...