Recent content by Csirny

  1. C

    M5r2 shifting problems

    Well with some advice from Dave I decided to replace the clutch disk. Once I started digging in more I found that the shim I put behind the flywheel was causing it to run out. I replaced everything and made sure to torque the flywheel and pressure plate to factory spec and check to see if it was...
  2. C

    M5r2 shifting problems

    Hi Norm. I tried this method last summer. Still no change. I might give it one more shot before I pull the thing apart again. I found another post with a similar problem and it was a bad clutch disk
  3. C

    M5r2 shifting problems

    I thought synchros and blockers were the same thing. I could be wrong on that. The wheels spin with the clutch pushed in. And the pilot bearing was also replaced and a light dab of grease on the splines for the clutch disk.
  4. C

    M5r2 shifting problems

    It's been an ongoing problem for the past 5 years. The car doesn't want to go into gear from a stop and is sometimes hard shifting. It seems like the more I drive the worse it gets. When I started this project I originally pulled the transmission to replace the synchros and when I reinstalled it...
  5. C

    Water pump pulley damaged

    No. I never had one on the original one. It just had regular bolts and washers. Yeah I also don't think riveting a plate on would work after looking at it again. It seems pretty good now with the bolts and spring washers. I'd like to use a plate like that though. I used stainless button head...
  6. C

    Water pump pulley damaged

    Well checking over some more things on my car today I found the water pump pulley bolts had come loose and damaged the pulley. Will it still hold like this? I'm going to put in it back together with loc-tite and spring washers for now. I'm going to see if I can get just that pulley (it's the...
  7. C

    Leaking timing chain cover

    I'm looking for some advice. I was underneath my car today and noticed a little coolant on the block. I'm pretty sure it is coming from the timing chain cover where it meets the block. I had everything degreased and cleaned up from battling numerous coolant leaks this summer. My question is can...
  8. C

    Abs light stays on

    Innova 3143 will read engine and abs codes and 3145 will NOT read abs.
  9. C

    1990 front left wheel speed sensor

    Does anybody have a good front left wheel speed sensor? ( Drivers side)
  10. C

    Needs better engine cooling

    I don't know how accurate the factory guage is. I just hooked up an extra temp gauge this year and with the temperature at 92 today I hit just over 200* idling in a driveway with the AC running. And I ran about 190* driving. I have a factory radiator but my car is tuned to run the fan at lower...
  11. C

    EEC compatibility

    I'm pretty sure all the difference between the auto and manual can be changed with the quarter horse and binary editor. You can get both of the calibrations off the binary editor website. Load one up and compare the difference to the other. There is a feature in BE that allows you to do this.
  12. C

    Completely parted out 91 SC, white with red cloth

    I'm looking for a front left wheel speed sensor for my 1990. Do you have any
  13. C

    Headlight high beam problem

    I'm having a problem trying to get my high beams to operate properly. Right now the flash to pass works but the regular high beams do not. Last year I replaced the MFS with a new one.(New old stock Blue) this worked for a summer and then the same problem happened again before I put the car away...
  14. C

    Motor mounts

    Thanks guys I will definitely get a bolt back in there
Back
Top