G
Reaction score
1

Latest activity Postings About

    • G
      gbabione replied to the thread Switching ABS to Conventional..
      I have the booster and mc installed. I used both parts for a 90 base. When I was doing a bench bleed of the mc, I had to leave it sit...
    • G
      gbabione replied to the thread Switching ABS to Conventional..
      That's what I thought about doing. I've been looking around work for some rubber the right thickness
    • G
      gbabione replied to the thread Switching ABS to Conventional..
      Firewall. The old one obviously is a 4-hole. It also has rust and brake fluid caked on it. If I don't find new, I could see if the old...
    • G
      gbabione replied to the thread Switching ABS to Conventional..
      Is there a part number for the power booster gasket? I didn't get one with the booster I ordered and I can't find a number anywhere.
    • G
      gbabione replied to the thread Abs pump motor FIXED!!!!!.
      The tip of the center tab looks like a contact, but I can't figure out how it would be installed to make contact with the other one.
    • G
      gbabione replied to the thread Abs pump motor FIXED!!!!!.
      Where does this piece go? It was on one of the magnets.
      • 20221109_155001.jpg
    • G
      gbabione replied to the thread Abs pump motor FIXED!!!!!.
      I don't have access to a dyno. Doing remote with David Dalke. At the point needs road tuning.
    • G
      gbabione replied to the thread Abs pump motor FIXED!!!!!.
      Yeah I don't plan on it lasting. I am just hoping it works long enough to be able to finish tuning it before my time runs out for the...
    • G
      gbabione replied to the thread Abs pump motor FIXED!!!!!.
      I posted in this one just because I had seen someone had rebuilt the motor. The other posts are for troubleshooting the whole issue...
    • G
      gbabione replied to the thread Abs pump motor FIXED!!!!!.
      It's not fixed. I need to know how these tabs go. If the motor doesn't run after that, I'll be converting. Thanks for all of your help.
    • G
      gbabione replied to the thread Abs pump motor FIXED!!!!!.
      I just had to tear my motor apart and clean it out. It was locked up from all of the crud in it. Although this is an old thread, I hope...
      • 20221106_214750.jpg
      • 20221106_214647.jpg
    • G
      gbabione replied to the thread Switching ABS to Conventional..
      My ABS pump motor is tied up. I'm trying to take it apart to clean it up to see if it'll run. If not, I'm going this route. I have...
    • G
      gbabione replied to the thread ABS pump motor.
      I like that, bang on something. I'd be afraid of breaking something like a magnet if they're still good. I saw a picture of one tore...
    • G
      gbabione replied to the thread ABS pump motor.
      I've got those two pieces off. I can't get the next piece out that the brushes are attached to. As soon as I can get that out, I'll be...
    • G
      gbabione replied to the thread ABS pump.
      I need to remove the brush holder. Does anyone know how it comes out?
  • Loading…
  • Loading…
Top