Recent content by JimmyMan

  1. J

    1990 SC will start then immediately die

    what about the ground behind the fuel rail, that ground is just for the injector harness. I would also use that harness to check the resistance of the injectors. I have had a few injectors fail over the years and it will drive you crazy.
  2. J

    89 clutch pedal

    looking for a 89 clutch pedal shipped to 01529
  3. J

    parting out 2 1990 supercoupes.....

    so what about a price with whatever parts you would include them with
  4. J

    parting out 2 1990 supercoupes.....

    I am looking for a set of the brackets that are riveted to the rear quarter and hold the body molding. How much plus shipping to 01529?
  5. J

    Custom gauge cluster

    you're right about the view being limited. now that i've seen what you've done, i'm thinking of trying the same thing. I will try painting the bezels black. the b terminal is not on the dimmer, the lighting circuit is seperate.
  6. J

    Custom gauge cluster

    that is correct. i actually took the gauges out of the cups and put them in the cluster with very little modification.
  7. J

    MA state inspection

    safety check only for 96 and older
  8. J

    helpp need to find a new rag joint

    there won't be a direct replacement, but i know for a fact that you will find the new rubber in the HELP! section. I think they're dorman parts.
  9. J

    Rear Wheel Bearing Replacement

    I have used both 20 and 12 ton presses on these. The best way I found was to heat the whole hub with the bearing in it to about 200 degrees(I used my oven). You still need the press but it slides right out. I usually leave the new bearing in the freezer for a couple hours and install it while...
  10. J

    Valuation

    I went to a car show a couple years back with my 89. When I pulled in they put me next to a 93 notch with a turbo. Needless to say there was a crowd around the Mustang and the Tbirdy got no attention. Anyway, a guy pulls next to me with a Viper. He gets out and immediately starts talking to me...
  11. J

    Suspension Bushing Questions...links included

    The moog bushings are much stiffer, better road feel. The tradeoff is they are require more maintenance.
  12. J

    Suspension Bushing Questions...links included

    For the strut rod bushings I use Moog. I have to change the frame side every 3 to 4 years, but they are lifetime warranty. I put about 10,000 miles a year on the car.
  13. J

    1990 SC won't pass RI state inspection

    I would check the ect on the manifold, if it's bad the car will run really rich because it will always think the engine is cold. I know the Haynes manual has the resistance specs.
  14. J

    Mustang mufflers?

    i recently put on a set from an 07 and they sound good. no drone to speak of. it's pretty quiet at idle and has a low rumble when you get on it. these are a lot of work to get on though. i had to cut off the rear tow points because they are very wide.
  15. J

    Autometer Gauges Inside Stock Cluster

    they are 2 1/16, i did not try the boost because i did not have one. i can tell you that would be a real challenge because it is connected to the fuel gauge. the gauges went in almost too easy. when i pulled the autometer gauges out of the pods i was surprised to see how similar they are to our...
Top