Jweeks

I'm confused what you are using to read the codes. Looks like you are using an adaptor cable from OBD1 to OBD2 and trying to scan with...

The fact that the relay(s) are clicking leads me to believe that your reader is able to comminicate with the ECM & is initiating a...

Thank you, I was unsure what module that was. I'll have to do alittle more research. Now if something is going on with those relays...

How would you jump the test port? Similar to the OBD1 90s style? With the 2 point key to test it?

I tried reading the codes a couple days ago I bought an adapter to obd2 to the ford 7 pin on these cars. Now my reader turns on when I...

Have you made an effort to inspect/clean the MAF? As I recall, if you disconnect the harness at the MAF with the engine running, you...

Yes, I have cleaned the MAF and throttle body just a couple weeks ago and seemed to help somewhat. I did put a new air filter on around...

I did do a combustion gas leak test today, safe to say it did not turn yellow as I tested it i waited for fans to turn on and thermostat...

I'd suggest you do a test for combustion gasses at the coolant expansion tank. If there is an Autozone nearby, that test kit used to be...

Sounds like a head gasket issue. Early Ford EEC-lV systems didn't give sensor data. With a head gasket failure, you will often get...

A lot of possibility's really. Wait until you are able to read codes, rather then clearing them & see what direction that takes you...

I have a 89 sc when my car is running it puffs out alot of white smoke and it smells just like gas seems to idle alittle rough. I do...

Thanks, I will be changing the fluid in the replacement with gm fluid that I have lying around. I've been waiting for the next nice day...

See this link on changing super charger oil: http://www.sccoa.com/forums/showthr...il-change-question&highlight=supercharger+oil...

Understood, check the oil level in the replacement unit or just change it I guess. A lot simpler to drain old when its off.