Kevin92

Yes, I'm now using dual 255 lph high pressure Walbro pumps and upgraded wiring. It's a tight fit in the stock late model fuel tank and...

A few years back I had a gas leak from the fuel pump and had it replaced with a walbro 190 I purchased of lmr.com.

Wow cool stuff man, it's going the be really awesome to see it running again. It's nice to see me and others getting their T-Birds going...

Towards the end of HS I started my engine build. It was an 03 Grand Marquis engine I got for $300. Tore it down, went through everything...

Ok. More on the car. As stated Ive had this car since before I could drive. It has been in my family since new, first bought in Fort...

Cool thanks for the replies, just asking since my car is on a lift at a friend's house. I'm getting my new engine installed and getting...

Not a problem, I had that same pump for several years, then a 255 lph hi pressure for even more years on the stock wiring.

If its been a few years already & you haven't had a issue, I'd say its fine. I think it would blow the fuse before it would ever damage...

I had my stock fuel pump replaced a few years ago with a walbro 190. Its using stock harness, will the wires hold up or will the pump...

I think this is really cool so I am going to post it. Here are photos of my 90 SC from 5 years ago, on an old thread here. It was being...

I havnt had alot of time to do much to the car for a while now after the new 4.2 and cooling system upgrades. I think I finally have it...

Saturday the 23rd was the cars and I first drift event. Was a blast. Above are photos of my best run, which as a whole was still not...

No photos today. Car wasnt fully ready, but neither was I. My helmet didnt arrive until after I had already got back home, so I was...

Hello to everyone on SCCoA, Sadly I am selling my 95 SC. This is most likely the cleanest one you will find available. Current mileage...

Got the car aligned. Since I did full suspension rebuild, it was horrible. Fronts were toed in 3° each, rear driver was 2° in, camber...