Recent content by MIKE 38sc

  1. M

    Hand Crafted Aluminum Radiators:

    Both rads shipped out Tuesday! Sorry but they will not let me build rads in the hospital!!!! I'm out of the rad buiseness. The rad shop is closed!
  2. M

    Wedding Songs....

    The music that the band played on the Titanic as it sank would be good.
  3. M

    Just got done gasket matching my exhaust ports, take a look

    Whew!!!!!! You sure like to take big bites dont you? LOL!!!!!! :p Bigger exhaust valves will help the SC engine since its constipated on that side. DO NOT weld on your heads with a MIG welder PERIOD!!!!!! DO NOT TIG weld on your heads unless you are properly setup to stress relieve the heads...
  4. M

    Hand Crafted Aluminum Radiators:

    Thats OK I understand stress believe me. ;) I got confused when I was searching in orders placed 4 months ago and could not find. I knew that all of those had shipped out already but I finaly found it in the orders from 3 months ago where it had been stuck inside of an envelope of a diffrent...
  5. M

    ABS Decal - Photo Needed

    That decal should read: WARNING this unit could fail at any moment!!!!! Ford does not service this system, GOOD LUCK!!! :p :p :p Sorry I could'nt resist. LOL!!! :D
  6. M

    Good transmission shop in ILLINOIS

    Oh no not again. :eek: Dude I dont think auto's like you. :confused: I just dont know what to say if you've lunched the Lentech. :confused: I hope you get things straightened out.
  7. M

    Just got done gasket matching my exhaust ports, take a look

    No it does'nt flake off if you make sure the surface is properly preped. Those guy's supply most of the big coatings applicators with there coatings. Remove all your masking materials before bakeing, just be very carefull as the coatings are fragile until baked. I've used that stuff on MX bike...
  8. M

    need partS?

    Color does'nt matter, none of them will match anywhooo. ;)
  9. M

    need partS?

    How much for a right rear qaurter? HeHe.......seriously.
  10. M

    Just got done gasket matching my exhaust ports, take a look

    I would'nt spend too much time polishing your CC's because that Ceramic coating you plan on useing needs a sandblasted surface in order for it to adhere to the applied surface. You will also need to sandblast the valvefaces and piston tops. DO NOT use glassbeads as they will embed and cause the...
  11. M

    Hand Crafted Aluminum Radiators:

    I've finaly figured out who you are and just located your info. I'm very sorry but your info got mixed up in a large pile of stuff from when I fled my house dureing my seperation from the wife. I'm very sorry for this and you will have your rad this week. :o :o :o :o :o :o :o
  12. M

    Hand Crafted Aluminum Radiators:

    Yes I can build that. cost is $310 + shipping.
  13. M

    Hand Crafted Aluminum Radiators:

    PLEASE email me at mike38sc@bellsouth.net so that I can find out whats going on. :confused:
  14. M

    Hand Crafted Aluminum Radiators:

    Yes the AOD unit has a HP heat exchanger installed. The top hose nipple is just a tad larger in diameter than the stocker because you cant get nipples the same diameter as the stock SC.(there an oddball size) However the stock hoses fit just fine. With the MP FMIC version of the rad you will...
Back
Top