Recent content by Mike Puckett

  1. Mike Puckett

    WANTED 1994 SC cluster surround trim & TAN driver door panel

    I've got a tan door panel. I'll check it tonight and make sure it's in good condition.
  2. Mike Puckett

    Rough, miss-like idle

    I have had fouled O2 sensors cause a bad misfire. It would barely run enough to drive around the block. After replacing them it ran normally.
  3. Mike Puckett

    Rough, miss-like idle

    Sounds like DIS or coil pack problem or any connection between them. Once had an idle stall problem which turned out to be the sc belt rubbing on the wire bundle to the cam and crank sensors, so you never know what you might find.
  4. Mike Puckett

    Rough, miss-like idle

    You might want to check your O2 sensors, also. A bad O2 sensor can make it run really rough.
  5. Mike Puckett

    Southeast SCs - Any meetup in the works?

    PM me your phone number and I'll call you next time we do something.
  6. Mike Puckett

    Southeast SCs - Any meetup in the works?

    Every once in awhile we get together for lunch on Friday over here in the Norcross Tucker area. There's 3 of us who still daily drive our SC's. We can do a Sunday afternoon lunch meet if enough show up. We usually have trouble getting people to show up so don't do too many get togethers on...
  7. Mike Puckett

    Crank Position Sensor

    I ordered one online from NAPA but I heard nothing back so I called them to follow up and was told that they are not available at all even though they still show up on their website.
  8. Mike Puckett

    93 HVAC fan control module

    Oh OK. Thanks.
  9. Mike Puckett

    93 HVAC fan control module

    That looks like it. How much?
  10. Mike Puckett

    93 HVAC fan control module

    I can't tell for sure and I don't have access to it right now. How thick is the heat sink under the transistor? Edge view?
  11. Mike Puckett

    93 HVAC fan control module

    I don't have possession of it right now but it is about 2.5" square and about an inch thick with a large round power transistor mounted on a heat sink on one side of the module.
  12. Mike Puckett

    93 HVAC fan control module

    I'm needing the fan control module for a '93. This is the small module with a power transistor and heat sink that is mounted under the dash in front of the blower fan for the hvac and just behind the glove box.
  13. Mike Puckett

    Looking for an ABS pump motor

    I've got a bad one. It's tight but you can turn the shaft with pliers. You can have it for shipping, the pump, too if you want.
  14. Mike Puckett

    Needing EEC for 91 AOD

    Thanks for the thought but they have to be the exact type. A COS was tried but it didn't work.
  15. Mike Puckett

    Needing EEC for 91 AOD

    The code is X1A2. There is also F1WF-BC on it as well.
Top