Search results

  1. Fastbull

    VIN Tracing

    I recently purchased a 35th SC and need to do a vin tracing with pencil and paper to register and transfer title of the vehicle. Does anyone know of another vin plate on the car that has the raised digits like the dash tag that are more easily accessible for a tracing? Thank you. -Matt
  2. Fastbull

    1990 sc aod

    The good: Tons of new parts installed within the last 2k including: Tires Kumho Ecsta ASX cost $600, head gastkes, valve stem seals, all upper engine gaskets, water pump, all alluminum radiator, coolant temp sensor, thermostat, coolant hoses, accessory and supercharger belts, oxygen sensors...
  3. Fastbull

    1990 sc aod

    1990 Ford Thunderbird SC, auto, 133k, $2000 obo The good: Tons of new parts installed within the last 2k including: Tires Kumho Ecsta ASX cost $600, head gaskets, valve stem seals, all upper engine gaskets, water pump, all alluminum radiator, coolant temp sensor, thermostat, coolant hoses...
  4. Fastbull

    FS 1990 SC AOD Blown Head Gaskets

    1990 Thunderbird SC with AOD, Don't know how many miles odometer read 109k when I bought it in Feb 2009 and replaced it with a working one that reads 131k. Car has sat for about 6 months with blown head gaskets I just replaced them in the last couple weeks but it seems they are still leaking and...
  5. Fastbull

    1990 Ford Thunderbird

    Additional Photos More photos
  6. Fastbull

    1990 Ford Thunderbird

    Casey, Are you about done ? David
  7. Fastbull

    Bubbles in expansion tank

    Is there any other reason other than blown head gaskets that there would be bubbles in the expansion tank? Just put this car back together finnaly after 6 months because of head gaskets and dont want to do it again. Thanks. -Matt
  8. Fastbull

    Rear Subframe

    Looking for a stripped down rear subframe for pickup in the Houston/Galveston area. Thanks. Matt
  9. Fastbull

    Broken Rear Subframe Bolt

    Bracket going to the body was rusted through anyway think I broke the nut off the backside of the through bolt. I read up on it and just need to know where to drill the hole to get at the backside of the nut. Also is ford the only source of supply for a new subframe bushing and bolt I completely...
  10. Fastbull

    Houston/Galveston

    Seeing who is in the area. If there are any meets going on etc. Just got a 90' SC about 3 months ago and finaly have it running reliably. I'm located in Jamaica Beach on the Island and looking to get involved in the local SC community hopefully. Matt
  11. Fastbull

    SCP Polyurethane LCA bushings

    Has anyone one else got these and had the cupped washers not fit into the new bushings sleeve on the lower control arm and if so what was your remedy? I was thinking of just using regular washers but not so sure that is a good idea. Thanks.
  12. Fastbull

    Horrible Idle/Stalling, Lean Condition

    1990 SC Has extremley rough idle and stalls after about 30 seconds if you dont give it some throttle. It has a slight miss all the way though 2k rpm then runs fine. Runs extremely strong at WOT and makes full boost and is getting around 20 vac so no vac leak. It idled fine last week then I had...
  13. Fastbull

    Turn Signal Problem

    The turn signals work fine for about a minute after the car is first started then once it warms up stop working. The hazards work fine. I'm stumped anyone have any ideas. Thanks.
  14. Fastbull

    New to Super Coupe

    Just bought my first Super Coupe was between that or a SHO. Anyway its a 1990 got it for $1000, it runs but needs alot of work. I look forward to the day its in decent shape again and I can start modding it. I live in Galveston, Tx so if there is anyone in the area or any meets comming up I'm...
Top