Search results

  1. S

    supercharger pully

    If you want a 10% OD I would consider the Magnum Powers crank pulley. It cost a bit more but much less chance of belt slip.
  2. S

    Anyone in Arizona/Phoenix-Tucson area.

    I am out in East Mesa.
  3. S

    93 SC CEL code 214

    You were spot on KMT. I went through checking my grounds and I noticed I forgot to reinstall the body mount screw on the IRCM that I had replaced. Screwed that back in and cleared the codes. Drove about 4 miles and no CEL. As far as replacing the connector at the cam sensor, do you have a...
  4. S

    93 SC CEL code 214

    Pulled plug and cleaned added some dielectric grease. Thanks
  5. S

    New exhaust and dyno video 91 SC

    Looks great and Sounds awesome.
  6. S

    93 SC CEL code 214

    I have a 93 SC with 61,000 miles that I purchased non running with a blown engine. I have installed a new long block from SCUI and I am getting a CEL with code 214. My researched suggest that normally it is a cam sensor. Engine starts fine. No excessive cranking, starts on first crank each...
  7. S

    Anyone from Arizona, still here.

    Contact Dave at supercoupesunlimitedinc@gmail.com. He has some good used ones.
  8. S

    Anyone from Arizona, still here.

    Yes, I live in east Mesa.
  9. S

    93 SC to 92 SC dash swap questions

    I by passed the heater core when I installed the new motor 4 or so years ago. I though about replacing it but with no intentions of hooking it up I decided not to. No need for a heater in Phoenix AZ. Car is only a toy and is not daily driven.
  10. S

    replace supercharger tube "nut" with "V" bands or compression clamps?

    I use ultra gray on both connections on the top tube. If you disconnected the bottom I have been using the teflon seals on those two connection. I have removed and re-installed a few times with this method.
  11. S

    93 SC to 92 SC dash swap questions

    After pulling the old dash and comparing the wiring harness there was enough difference in them that I change out the entire harness. Not real difficult just time consuming.
  12. S

    93 SC to 92 SC dash swap questions

    The VMM wiring does not appear to be in the new dash and yes the 92 has the jbl system.
  13. S

    93 SC to 92 SC dash swap questions

    I plan on swapping a 93 SC dash into a 92 SC. The 93 has Premium sound, auto headlights, and no maintenance monitor. The 92 has JBL audio, no auto headlights, and the maintenance monitor. My question is will the entire wiring harness need to be swapped? Or just the wiring for for the JBL, the...
  14. S

    My new addiction therapy/reminder

    Great looking car. Wheels look great too.
  15. S

    My new addiction therapy/reminder

    Looks great.
  16. S

    New 20" wheels for my 91 SC

    Looks good. I considered buying those wheels as well.
  17. S

    Opinions / suggestions on what you think

    Keep in mind you can no longer buy them. if you remove them and decide later you want to add them back they are not easy to come by.
  18. S

    Wheels for my "new to me" SC

    I think the Saleen wheels look great on an SC. The only issue seems to be they are very very hard to come by. Finding them in stock has proven to by very difficult for me.
  19. S

    Brakes

    I don't recall if there is a rubber portion. If there is you don't want to cut it there. A tubing cutter will cut the hard line easily. Just be sure you have the correct fittings.
  20. S

    Brakes

    It most certainly is possible without disassembling half the engine. I think most went with a standard brake swap as it works just fine and is much cheaper so I am not sure how many have went the hydro-boost route. I purchase mine from Sweeting Performance Engineering Marketing & Design. I...
Back
Top