Search results

  1. Pablo94SC

    In case you didn't see it, MMP is scheduled to reopen in April.

    Link to my other post. http://www.sccoa.com/forums/showthread.php?t=118930 I'll be there with bells on and hope you guys will come out as well! Oh, and I'll need some place to store my street tires and jack when the slicks go on, so if you aren't racing... LOL ;)
  2. Pablo94SC

    Memphis Motorsports Park to reopen in April, 2011

    Just wanted to throw this out there to everyone near Memphis whose track has shut down. It's a short drive and has always been a top notch place to race. Plus, paved pits! :D http://www.racemir.com/
  3. Pablo94SC

    I've about had it... bearing??

    I finally got the car running decently and now this... http://s672.photobucket.com/albums/vv85/vodkakiller/?action=view&current=10052010002.mp4 I'm not sure, but I'm thinking a bad bearing. Crank pulley is also wobbling. The low frame rate hides most of it, but if you pay attention you can...
  4. Pablo94SC

    Power steering acting funny

    My power steering sometimes works at idle, usually when the car is cold, allowing the wheels to be turned easily while stopped. Other times the engine bogs down and it feels worse than a manual rack, requiring me to shift into neutral and rev the engine before I get any power assist. If I do...
  5. Pablo94SC

    Magnaflow 11226 mufflers

    !!!!!SOLD!!!!! Thanks for looking. These are the non-polished stainless steel, 4x9x14" body mufflers with a 2.5" center/offset inlet and outlet, and have been on the car for about 4k miles. They are quiet with a throaty grumble at idle and low RPM, and really open up at WOT. Front seat...
  6. Pablo94SC

    Is my driveshaft failing/out of balance?

    Long story short, car is smooth as silk until about 70mph. The vibration almost completely disappears at 85mph, only to return at 100mph and make the car feel like it's in a paint mixer. Here's the troubleshooting list - New tires and wheels balanced/checked numerous times at 4 different...
  7. Pablo94SC

    Oil sludge in #6 cylinder intake... feedback requested

    Here's the back story... for a while now I've had a cold idle miss that would quickly go away after 30 seconds or so, or after a quick rev to 3000+rpm. Also had occasional bubbles in the overfill tank. Both started after removing the lower intake manifold to clean it out after lots of oil got...
  8. Pablo94SC

    moving dip stick tube

    Can the dip stick tube be adjusted or moved so it's not blocking the #5 spark plug hole? It's making it damn near impossible for me to get my compression tester fitting in the hole.
  9. Pablo94SC

    Parted out early model short block

    Prices reflect going rates on here, but feel free to make a reasonable offer on any of these parts. I'll charge actual shipping on most of the larger items due to size & weight. Connecting rods - $50 (Pistons are still on the rods if you want them for any reason) Crank - SOLD Camshaft - $25...
  10. Pablo94SC

    Memphis area mini-meet June 5th!

    I know you guys might be a little far away, but wanted to extend the invite. Hoping to have a mini-meet June 5th in the Memphis area. I'm thinking everyone meets up at Shelby Farms, then head off somewhere fun for food and drinks. It'd be great chance for everyone to get to know the locals...
  11. Pablo94SC

    Memphis area mini-meet June 5th!

    I know you guys might be a little far away, but wanted to extend the invite. Hoping to have a mini-meet June 5th in the Memphis area. I'm thinking everyone meets up at Shelby Farms, then head off somewhere fun for food and drinks. It'd be great chance for everyone to get to know the locals...
  12. Pablo94SC

    Memphis area mini-meet June 5th!

    Hoping to have a mini-meet June 5th in the Memphis area. I'm thinking everyone meets up at Shelby Farms, then head off somewhere fun for food and drinks. It'd be great chance for everyone to get to know the locals and talk/gripe about our SC's. :D If you're planning to attend, just send a...
  13. Pablo94SC

    Feeler thread... MP2 case and MP Inlet

    Gauging interest here for the time being. If I get an offer I like, I'll sell. I'll be keeping the snout and rotor pack, so it will only be the MP2 case and MP inlet for sale. I did have to heli-coil one of the blower top bolt holes, but it seals without leaks and was good enough with 10% OD...
  14. Pablo94SC

    Moonroof questions after maintenance

    My moonroof shade had been off it's track for a while and one of the air deflector's arms had broken off its mounting tab causing it to rattle, so when I found one in the junkyard I picked it up, replaced it and fixed the shade. Now the moonroof wants to drag when closing the last 1-2"...
  15. Pablo94SC

    Thermostat housing backing plate

    I know many of you, like me, have a thermostat housing that seems to warp and leak just by looking at the damn thing. So I got on the horn with Charles over at MP and asked what he thought about making a plate that can be welded onto the housing to stiffen it up. He doesn't have a price yet...
  16. Pablo94SC

    Not mine, but 94 5spd for sale in Memphis

    I ran into a guy with a 94 5-spd who was looking to sell. It's black on tan leather with about 109k on the clock. Interior and leather were almost perfect sans the broken DS seat trim (the piece that goes over the buttons). Paint was decent, but clearcoat was starting to fail on the roof...
  17. Pablo94SC

    C&L Gold sample tube

    Thinking $30 + shipping. PM me if you're interested.
  18. Pablo94SC

    If you're looking for an LC-1...

    Got a LC-1 kit today with a blue DB gauge for $185 shipped off eBay today. Look for username abad71camaro. Great deal as they normally go for $230.
  19. Pablo94SC

    94 brakes are still spongy.

    I'm running out of ideas here guys. My brakes still are spongy despite replacing the brake lines, the front calipers, all pads and rotors, the master cylinder, and bleeding the system numerous times using the ABS break-out tool. Even swapped an old, known good check valve in the booster...
  20. Pablo94SC

    Upper cable on TB bracket - cruise control?? (94)

    Stupid questions I guess, but here goes... what's the cable on top of the throttle cable for on the late model cars? It runs from the bracket to the front of the DS fender. Is that for cruise?
Top